Removal [07/2020 - ]: Procedure

Refer to REMOVAL [07/2020 - ]

1. Disconnect the connector.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Detach the claws and remove rear corner ultrasonic sensor.

   NOTE:

   Before removing the sensor, make sure to mark the sensor and rear bumper cover so that each sensor can be returned to its original position.

HINT: 

Use the same procedure described for the rear corner ultrasonic sensor.

HINT: 

• Perform the following procedure only when replacement of a rear corner ultrasonic sensor retainer is necessary.
• When removing the rear corner ultrasonic sensor retainer, heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light.

1. Heat the rear bumper assembly and rear corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.

   Standard

   Item	Temperature
   Rear Bumper Assembly	20 to 30°C (68 to 86°F)
   Rear Corner Ultrasonic Sensor Retainer

   WARNING:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Heated Part
   *b	Heat Light

   • Do not touch the heat light and heated parts.
   • Touching the heat light may result in burns.
   • Touching heated parts for a long time may result in burns.
2. Remove the rear corner ultrasonic sensor retainer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

• Perform the following procedure only when replacement of a rear center ultrasonic sensor retainer is necessary.
• Use the same procedure described for the rear corner ultrasonic sensor retainer.