Installation [06/2018 - 08/2020]: Procedure

INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Airbag Connector
*b	Airbag Connector Locking Button
	Push in this Direction

NOTE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

Push in the airbag connector locking button to install the airbag connector.
Engage the 3 claws to temporarily install the lower No. 2 instrument panel airbag assembly.
Install the lower No. 2 instrument panel airbag assembly with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTE:
Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

INSTALL LOWER INSTRUMENT PANEL LH
Refer to PROCEDURE - Step 29
INSTALL LOWER INSTRUMENT FINISH SUB PANEL
Refer to PROCEDURE - Step 30
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 31
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 32
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 33
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 8
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for Gasoline Model: Refer to PROCEDURE - Step 2

for HV Model: Refer to PROCEDURE - Step 2

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [06/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]
PERFORM DIAGNOSTIC SYSTEM CHECK
for Gasoline Model: Refer to DTC CHECK / CLEAR [06/2018 - ]

for HV Model: Refer to DTC CHECK / CLEAR [06/2018 - ]
INSPECT SRS WARNING LIGHT
for Gasoline Model: Refer to OPERATION CHECK [06/2018 - 08/2021]

for HV Model: Refer to OPERATION CHECK [06/2018 - 08/2021]