Installation [06/2018 - 08/2020]: Procedure

1. Temporarily install the rear suspension arm bracket to the rear trailing arm assembly with the bolt and nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Insert the bolt from the inside of the vehicle.

2. Position the rear trailing arm assembly as shown in the illustration.

   Reference Length (A)

   120 mm (4.72 in.)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Upper Surface of Rear Suspension Arm Bracket

3. Fully tighten the nut.

   Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf) 

1. Engage the 4 claws and install the rear suspension arm cover.

1. Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
2. Install the rear trailing arm assembly to the vehicle with the 4 bolts.

   Torque: 90 N.m (918 kgf/cm, 66 ft.lbf) 

3. Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts.

   Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

1. Install the No. 2 parking brake wire assembly to the rear trailing arm assembly with the nut.

   Torque: 15.5 N.m (158 kgf/cm, 11 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Engage the 2 clamps.

1. Install the No. 2 parking brake wire assembly to the rear trailing arm assembly with the nut.

   Torque: 15.5 N.m (158 kgf/cm, 11 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Engage the clamp.
3. Engage the guide and install the wire harness bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Guide
   *b	Clamp

4. Install the nut.

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

5. Engage the clamp and install the No. 2 parking brake wire assembly to the wire harness bracket.
6. Connect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  5

1. for RH Side:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the No. 1 floor under cover with the 2 grommets (B).
   2. Install the bolt and clip (A).

      Bolt 

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

1. for LH Side:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the No. 2 floor under cover with the 2 grommets (B) and clip (C).
   2. Install the bolt and clip (A).

      Bolt 

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

1. for RH Side:

   See step  8

1. for LH Side:

   See step  9

Refer to PROCEDURE - Step 1

Refer to ADJUSTMENT [06/2018 - 08/2020]

*1: for LED type turn signal light

*1: for LED type turn signal light