Installation [08/2020 - ]: Procedure

INSTALL SUSPENSION TOWER DAMPER
1. Install the suspension tower damper to the front bumper extension sub-assembly LH and front bumper extension sub-assembly RH with the 4 bolts.
  Torque: 27.5 N.m (280 kgf/cm, 20 ft.lbf)
  
  NOTE:
  Do not extend or compress the damper.
INSTALL NO. 1 ENGINE UNDER COVER
for A25A-FKS: Refer to PROCEDURE - Step 72 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 73 [08/2021 - ]

for A25A-FXS: Refer to PROCEDURE - Step 43 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 44 [08/2021 - ]

for 2GR-FKS: Refer to PROCEDURE - Step 70
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
for A25A-FKS: Refer to PROCEDURE - Step 73 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 75 [08/2021 - ]

for A25A-FXS: Refer to PROCEDURE - Step 44 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 45 [08/2021 - ]

for 2GR-FKS: Refer to PROCEDURE - Step 71
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
for A25A-FKS: Refer to PROCEDURE - Step 74 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 75 [08/2021 - ]

for A25A-FXS: Refer to PROCEDURE - Step 45 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 46 [08/2021 - ]

for 2GR-FKS: Refer to PROCEDURE - Step 72