LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> ES 300h Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (2 Of 3) >> Front Passenger Airbag Assembly >> Installation [08/2021 - ] >> Procedure

Installation [08/2021 - ]: Procedure

  1. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY 
    1. Engage the 3 hooks.
      GTY813686Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Push in the instrument panel passenger airbag assembly to engage the 3 hooks.
    3. Install the instrument panel passenger airbag assembly with the 2 screws.
      GTY835729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  3. CONNECT INSTRUMENT PANEL WIRE 
    1. Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.
    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the 2 airbag connectors of the instrument panel wire to the instrument panel passenger airbag assembly.
      GTY1085135Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Airbag Connector
      *b Airbag Connector Locking Button
      Push in this Direction
      NOTE:
      • When connecting any airbag connector, take care not to damage the airbag wire harness.
      • Be sure to only connect the connectors to each corresponding color.
    4. Push in the 2 airbag connector locking buttons as shown in the illustration to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
    5. Engage the clamp.
  4. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals