LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> ES 300h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Starting System (2GR-FKS) - Service Information) >> Starter >> Installation [06/2018 - ] >> Procedure

Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 46 N.m (469 kgf/cm, 34 ft.lbf) 

    2. Connect the engine wire to the terminal 30 with the nut.

      Torque: 9.8 N.m (100 kgf/cm, 87 in.lbf) 

    3. Close the terminal cap.
    4. Connect the starter assembly connector.
  2. INSTALL BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 41

  3. INSTALL ECM 

    Refer to PROCEDURE - Step 3

  4. INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 45

  5. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 46

  6. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 47

  7. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 2 [08/2021 - 09/2022] , or refer to PROCEDURE - Step 2 [09/2022 - ]

  8. INSTALL BATTERY 

    Refer to INSTALLATION [06/2018 - ]

scientia non olet · About LEMON Manuals