Installation [06/2018 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 350, 2023 Lexus ES 350, 2022 Lexus ES 350, 2021 Lexus ES 350, and 2020 Lexus ES 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adhesive 1344
*b	Oil Inlet Port

NOTE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:
Do not start the engine for at least 1 hour after installation.
Connect the engine oil pressure switch assembly connector.
Engage the clamp to connect the wire harness protector.

ADD ENGINE OIL
Refer to PROCEDURE - Step 8 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 8 [08/2021 - ]
CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [06/2018 - 07/2023] , or refer to PROCEDURE - Step 1 [07/2023 - ]
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 10 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 10 [08/2021 - ]
INSTALL FRONT FENDER APRON SEAL RH
Refer to PROCEDURE - Step 67