LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> ES 300h Base >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (A25A-FXS) - Service Information >> Oil Pressure Sensor >> Removal [06/2018 - 10/2019] >> Procedure

Removal [06/2018 - 10/2019]: Procedure

  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 8

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 7

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 9

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 10

  5. REMOVE OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY) 
    1. Disconnect the oil pressure sensor (oil pressure sender gauge assembly) connector.
    2. Using a 27 mm deep socket wrench, remove the oil pressure sensor (oil pressure sender gauge assembly) from the cylinder block sub-assembly.
      GTY753716Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals