Installation [06/2018 - 10/2019]: Procedure

1. Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Adhesive 1344
   *b	Oil Inlet Port

   NOTE:

   • Do not apply adhesive to the oil inlet port of the oil pressure sensor (oil pressure sender gauge assembly).
   • Install the oil pressure sensor (oil pressure sender gauge assembly) within 3 minutes of applying adhesive.
2. Using a 27 mm deep socket wrench, install the oil pressure sensor (oil pressure sender gauge assembly) to the cylinder block sub-assembly.

   Torque: 15 N.m (153 kgf/cm, 11 ft.lbf) 

3. Connect the oil pressure sensor (oil pressure sender gauge assembly) connector.

Refer to PROCEDURE - Step 6

Refer to PROCEDURE - Step 42

Refer to PROCEDURE - Step 43

Refer to PROCEDURE - Step 44

Refer to PROCEDURE - Step 45