Installation [06/2018 - ]: Procedure

INSTALL ENGINE OIL LEVEL SENSOR
1. Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
  Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
2. Install a new clip to the engine oil level sensor.
3. Connect the engine oil level sensor connector.
INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
Refer to PROCEDURE - Step 12 [06/2018 - 07/2019] , or refer to PROCEDURE - Step 12 [07/2019 - 10/2019] , or refer to PROCEDURE - Step 12 [10/2019 - 08/2021] , or refer to PROCEDURE - Step 12 [08/2021 - ]
ADD ENGINE OIL
Refer to PROCEDURE - Step 5 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 5 [08/2021 - ]
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 6 [08/2021 - ]
CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [06/2018 - 07/2023] , or refer to PROCEDURE - Step 1 [07/2023 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 42 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 43 [08/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 43 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 44 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Refer to PROCEDURE - Step 44 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 45 [08/2021 - ]
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Refer to PROCEDURE - Step 45 [06/2018 - 08/2021] , or refer to PROCEDURE - Step 46 [08/2021 - ]