LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> UX 250h Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display (Service Information) >> Trip Switch >> Inspection [10/2018 - ] >> Procedure

Inspection [10/2018 - ]: Procedure

  1. INSPECT TRIP SWITCH 
    1. Check the resistance.
      Fig 1: Trip Switch Connector End View
      GTY787893Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 ODO/TRIP Switch
      *a Component without harness connected
      (Trip Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        4 (A/B) - 7 (E) ODO/TRIP Switch pressed Below 1 Ω
        ODO/TRIP switch not pressed 10 kΩ or higher

        If the result is not as specified, replace the trip switch.

    2. Check illumination.
      GTY830075Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Trip Switch)
      1. Apply auxiliary battery voltage to the trip switch and check that it illuminates.

        OK

        Tester Connection Specified Condition
        Auxiliary battery positive (+) → 3 (ILL+)
        Auxiliary battery positive (-) → 8 (ILL-)        		 Illuminates

        If the result is not as specified, replace the trip switch.

scientia non olet · About LEMON Manuals