RL Speed Sensor Wrong Installation (X0453) [10/2018 - 07/2022]: Procedure

1. Using the Techstream, perform the Health Check.

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

Result: 

A 

See step  2

1. Check that the correct Part No. is installed for the corresponding part.

   Corresponding Part

   Rear Speed Sensor LH

   NOTE:

   If it is necessary to remove components in order to check the corresponding part, follow the relevant installation and removal procedures and precautions for those components.

   Result

   Result	Proceed to
   The corresponding part is the correct Part No.	A
   The corresponding part is not the correct Part No.	B

Result: 

B 

REPLACE REAR SPEED SENSOR LH (REAR AXLE HUB AND BEARING ASSEMBLY LH). Refer to  REMOVAL [10/2018 - 07/2022] 

Result: 

A 

See step  3

1. Using the Techstream, clear the Vehicle Control History (RoB).

   Chassis > Brake/EPB > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Using the Techstream, check for Vehicle Control History (RoB).

   Chassis > Brake/EPB > Utility 

   Tester Display
   Vehicle Control History (RoB)

   Result

   Result	Proceed to
   X0453 is not output	A
   X0453 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2018 - ] 

Result: 

B 

REPLACE REAR SPEED SENSOR LH (REAR AXLE HUB AND BEARING ASSEMBLY LH). Refer to  REMOVAL [10/2018 - 07/2022]