LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> UX 200 Base >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Diagnostic Codes (2 Of 2) & Circuit Tests) >> Lighting System >> Headlight Beam Level Control Actuator Circuit [07/2022 - ] >> Procedure

Headlight Beam Level Control Actuator Circuit [07/2022 - ]: Procedure

  1. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Drive The Leveling Motor Headlight leveling motor upward or downward operation Stop, Down or Up Perform the Active Test with the power switch on (READY) and vehicle stopped

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display
      Drive The Leveling Motor

      OK

      Headlight leveling motors operate normally.

      Result

      Result Proceed to
      OK A
      NG (for LH Side) B
      NG (for RH Side) C

    Result: 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [07/2022 - ] 

    Result: 

    See step  4

    Result: 

    See step  2

  2. CHECK NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH 
    1. Interchange the No. 1 headlight ECU sub-assembly LH with RH and connect the connectors.

      Refer to REMOVAL [10/2018 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  3

  3. CHECK OPERATION (AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM) 
    1. Check that the headlight leveling motor LH operate normally.

      Refer to OPERATION CHECK [07/2022 - ]

      OK

      Headlight leveling motor LH operate normally.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2018 - ] 

    Result: 

    NG 

    REPLACE HEADLIGHT UNIT LH. Refer to  DISASSEMBLY [10/2018 - ] 

  4. CHECK NO. 1 HEADLIGHT ECU SUB-ASSEMBLY RH 
    1. Interchange the No. 1 headlight ECU sub-assembly RH with LH and connect the connectors.

      Refer to REMOVAL [10/2018 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  5

  5. CHECK OPERATION (AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM) 
    1. Check that the headlight leveling motor RH operate normally.

      Refer to OPERATION CHECK [07/2022 - ]

      OK

      Headlight leveling motor RH operate normally.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to  REMOVAL [10/2018 - ] 

    Result: 

    NG 

    REPLACE HEADLIGHT UNIT RH. Refer to  DISASSEMBLY [10/2018 - ]