Inspection [10/2015 - ]: Procedure
- INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
- Apply 6.0 V (4 dry cell batteries in series) to the front door outside handle assembly LH and check that the light comes on.NOTE:
Do not apply more than 6.0 V.
OK
Condition Specified Condition Battery positive (+) → 1 (OLP)
Battery negative (-) → 3 (GND)Illuminates If the result is not as specified, replace the front door outside handle assembly LH.
*a Component without harness connected
(Front Door Outside Handle Assembly LH)
- Apply 6.0 V (4 dry cell batteries in series) to the front door outside handle assembly LH and check that the light comes on.
- INSPECT FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH
- Apply 6.0 V (4 dry cell batteries in series) to the front door outside handle assembly RH and check that the light comes on.NOTE:
Do not apply more than 6.0 V.
OK
Condition Specified Condition Battery positive (+) → 1 (OLP)
Battery negative (-) → 3 (GND)Illuminates If the result is not as specified, replace the front door outside handle assembly RH.
*a Component without harness connected
(Front Door Outside Handle Assembly RH)
- Apply 6.0 V (4 dry cell batteries in series) to the front door outside handle assembly RH and check that the light comes on.