LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 450hL >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Service Information) (2 Of 2) >> Rear Light Assembly >> Disassembly [08/2019 - ] >> Procedure

Disassembly [08/2019 - ]: Procedure

  1. REMOVE BACK-UP LIGHT BULB (for Bulb Type Turn Signal Light) 
    1. Turn the rear light socket and wire with the back-up light bulb as shown in the illustration to disconnect them as a unit.
      GTY676004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Remove the back-up light bulb from the rear light socket and wire.
  2. REMOVE REAR LIGHT SOCKET AND WIRE 
    1. for Bulb Type Turn Signal Light:
      1. Disconnect the connector to remove the rear light socket and wire.
        GTY646218Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. for LED Type Turn Signal Light:
      1. Disconnect the connector to remove the rear light socket and wire.
        GTY961554Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR LIGHT GASKET 
    1. for Bulb Type Turn Signal Light:
      1. Remove the rear light gasket.
        GTY646219Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        NOTE:
        • Be sure to remove all traces of the old rear light gasket from the vehicle body.
        • Do not reuse the removed rear light gasket. Be sure to install a new rear light gasket to prevent water ingress.
    2. for LED Type Turn Signal Light:
      1. Remove the rear light gasket.
        GTY961557Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        NOTE:
        • Be sure to remove all traces of the old rear light gasket from the vehicle body.
        • Do not reuse the removed rear light gasket. Be sure to install a new rear light gasket to prevent water ingress.
  4. REMOVE LICENSE PLATE LIGHT SHADE 
    1. for Bulb Type Turn Signal Light:
      1. Remove the 2 license plate light shades.
        GTY646217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        NOTE:
        • Be sure to remove all the traces of the old license plate light shade from the vehicle body.
        • Do not reuse the removed license plate light shade. Be sure to install a new license plate light shade to prevent water ingress.
    2. for LED Type Turn Signal Light:
      1. Remove the 2 license plate light shades.
        GTY961550Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        NOTE:
        • Be sure to remove all the traces of the old license plate light shade from the vehicle body.
        • Do not reuse the removed license plate light shade. Be sure to install a new license plate light shade to prevent water ingress.
  5. REMOVE REAR LIGHT LENS AND BODY (for Bulb Type Turn Signal Light) 
scientia non olet · About LEMON Manuals