Inspection [10/2015 - ]: Procedure
- INSPECT REAR COMBINATION LIGHT ASSEMBLY LH
- Apply auxiliary battery voltage to the rear combination light assembly LH and check that the lights come on.
*a Component without harness connected
(Rear Combination Light Assembly LH)OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1 (B)
Auxiliary battery negative (-) → Terminal 3 (E)Taillight comes on Auxiliary battery positive (+) → Terminal 2 (STP)
Auxiliary battery negative (-) → Terminal 3 (E)Stop light comes on Auxiliary battery positive (+) → Terminal 4 (TRN)
Auxiliary battery negative (-) → Terminal 3 (E)Turn signal light comes on*1 Auxiliary battery positive (+) → Terminal 4 (TRN) and 6 (TRN2)
Auxiliary battery negative (-) → Terminal 3 (E)Turn signal light comes on*2 - *1: for Turn Signal Light Bulb Type
- *2: for Turn Signal Light LED Type
If the result is not as specified, replace the rear combination light assembly LH.
- Apply auxiliary battery voltage to the rear combination light assembly LH and check that the lights come on.
- INSPECT REAR COMBINATION LIGHT ASSEMBLY RH
- Apply auxiliary battery voltage to the rear combination light assembly RH and check that the lights come on.
*a Component without harness connected
(Rear Combination Light Assembly RH)OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 1 (B)
Auxiliary battery negative (-) → Terminal 3 (E)Taillight comes on Auxiliary battery positive (+) → Terminal 2 (STP)
Auxiliary battery negative (-) → Terminal 3 (E)Stop light comes on Auxiliary battery positive (+) → Terminal 4 (TRN)
Auxiliary battery negative (-) → Terminal 3 (E)Turn signal light comes on *1 Auxiliary battery positive (+) → Terminal 4 (TRN) and 6 (TRN2)
Auxiliary battery negative (-) → Terminal 3 (E)Turn signal light comes on *2 - *1: for Turn Signal Light Bulb Type
- *2: for Turn Signal Light LED Type
If the result is not as specified, replace the rear combination light assembly RH.
- Apply auxiliary battery voltage to the rear combination light assembly RH and check that the lights come on.