Installation [08/2016 - 08/2019]: Procedure

1. Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
   NOTE:

   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
2. Remove the 2 bolts and separate the rear lower shock absorber bracket sub-assembly from the rear axle carrier sub-assembly.
3. Install the rear trailing arm assembly to the rear axle carrier sub-assembly with the 2 bolts (A) and 2 washers.

   Torque: 150 N*m (1530 kgf*cm, 111 ft.*lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Install the rear trailing arm assembly to the vehicle with the 2 bolts (B).

   Torque: 150 N*m (1530 kgf*cm, 111 ft.*lbf) 

5. Install the rear lower shock absorber bracket sub-assembly to the rear axle carrier sub-assembly with the 2 bolts.

   Torque: 100 N*m (1020 kgf*cm, 74 ft.*lbf) 

6. Slowly lower the rear No. 2 suspension arm assembly.

1. Install the rear speed sensor to the rear trailing arm assembly with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

1. Connect the No. 2 parking brake wire assembly to the rear trailing arm assembly with the 3 bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Bolt (A) 

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

   Bolt (B) 

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

2. Install the No. 2 parking brake wire assembly to the rear axle carrier sub-assembly with the bolt.

   Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

3. Connect the No. 2 parking brake wire assembly connector.

See step  8

Refer to PROCEDURE - Step 1

Refer to ADJUSTMENT [08/2016 - 03/2018] , or refer to ADJUSTMENT [03/2018 - ]