Removal [08/2019 - ]: Procedure

PRECAUTION (w/ Kick Sensor)
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [08/2019 - ]
REMOVE DECK BOARD ASSEMBLY (w/ Kick Sensor)
Refer to PROCEDURE - Step 2
REMOVE REAR DECK FLOOR BOX (w/ Kick Sensor)
Refer to PROCEDURE - Step 4
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Kick Sensor)
Refer to PROCEDURE - Step 4
REMOVE REAR LIGHT COVER LH
for Bulb Type Turn Signal Light:

Refer to PROCEDURE - Step 24

for LED Type Turn Signal Light:

Refer to PROCEDURE - Step 25
REMOVE REAR LIGHT COVER RH
HINT:

Use the same procedure as for the LH side.

DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH

Apply protective tape around the quarter outside moulding sub-assembly LH and rear bumper assembly as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Using a 4 mm hexagon socket wrench, remove the screw.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the clip.

Pull back the edge of the rear wheel house liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Remove in this Direction (1)
	Remove in this Direction (2)

NOTE:

Do not apply excessive force when pulling back the rear wheel house liner LH.
To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly LH.

Disengage the clip to disconnect the quarter outside moulding sub-assembly LH from the rear bumper assembly.

DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH
HINT:

Use the same procedure as for the LH side.

DISCONNECT REAR WHEEL HOUSE LINER LH

Remove the 2 screws and grommet and disconnect the rear wheel house liner LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

Remove the 6 clips.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 2 luggage compartment side cover protector clip
	Remove in this Direction

Disengage the 2 No. 2 luggage compartment side cover protector clips as shown in the illustration.
Remove the 2 bolts and No. 2 luggage compartment side cover protector.

REMOVE REAR BUMPER ASSEMBLY

Remove the 4 screws.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 8 clips.

Disengage the 5 claws as shown in the illustration.

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

Disengage the 2 claws as shown in the illustration to remove the rear bumper assembly.

Remove in this Direction

w/ Intuitive Parking Assist System or Kick Sensor:
1. Disconnect the connector.