LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Transfer Case - Service Information) >> TRANSFER CASE FRONT OIL SEAL (for RH Side) >> Replacement [09/2015 - 08/2019] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal RH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
  1. Clear zero point calibration data and system information.
  2. Perform yaw rate and acceleration sensor zero point calibration and store system information.
  • VSC disabled or malfunctions
  • DTCs are stored
  • Slip indicator light illuminates
  • ABS warning light illuminates
 Refer to CALIBRATION [09/2015 - 08/2019]
scientia non olet · About LEMON Manuals