Removal [08/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [08/2019 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2019 - ]
REMOVE FRONT DOOR SCUFF PLATE RH
- w/o Rear No. 2 Seat
  Refer to PROCEDURE - Step 15
- w/ Rear No. 2 Seat
  Refer to PROCEDURE - Step 17
REMOVE COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 22
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 23

REMOVE 4WD ECU ASSEMBLY

Disconnect the 4WD ECU assembly connector.

Remove the bolt and 4WD ECU assembly.