Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during 4WD ECU assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision system | |||
| Intelligent clearance sonar system*1 | |||
| Lighting system (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | ||
| Parking assist monitor system | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [08/2019 - ] | ||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] | |
| 4WD ECU assembly (When replaced with a known good one from another vehicle)*2 | Clear zero point calibration data | Dynamic Torque Control AWD System | Refer to CALIBRATION [09/2015 - ] |
*1: When performing learning using the Techstream.
Refer to CALIBRATION [08/2019 - ]
*2: When the 4WD ECU assembly is replaced with a new one, calibration is unnecessary.