Installation [12/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
When 4WD ECU assembly is replaced with a known good one from another vehicle, it is necessary to perform calibration.

Refer to CALIBRATION [09/2015 - ]

INSTALL 4WD ECU ASSEMBLY

Install the 4WD ECU assembly with the bolt.

Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)

Stopper

INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 16 [12/2017 - 08/2019] , or refer to PROCEDURE - Step 16 [08/2019 - ]
INSTALL COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 17 [12/2017 - 08/2019] , or refer to PROCEDURE - Step 17 [08/2019 - ]
INSTALL FRONT DOOR SCUFF PLATE RH
- w/o Rear No. 2 Seat
  Refer to PROCEDURE - Step 48
- w/ Rear No. 2 Seat
  Refer to PROCEDURE - Step 54
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2017 - 08/2019] , or refer to INITIALIZATION [08/2019 - ]