Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System *1 | |||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | ||
| Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] | |
| Front wheel alignment adjustment | Calibration |
|
Refer to CALIBRATION [08/2019 - ] |
| Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement) |
|
|
Refer to CALIBRATION [08/2019 - ] |
| Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
|
|
Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
|
| Initialize No. 1 headlight ECU sub-assembly LH | Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | |
| Gas leak from exhaust system is repaired | Inspection After Repair |
|
Refer to INITIALIZATION [08/2019 - ] |
Replacement of
|
Perform the following procedures in the order shown:
|
|
Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to REGISTRATION [09/2015 - ] for Registration |
| Replacement of shift solenoid valve SL1 and/or SL2 | Perform Road Test to Allow ECM to Learn |
*1: When performing learning using the Techstream.