Installation [09/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL TRANSMISSION WIRE
- Apply a light coat of ATF to the O-ring of the transmission wire.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Install the transmission wire to the automatic transaxle case sub-assembly with the bolt.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- Connect the transmission revolution sensor (NC3) connector.
- INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Refer to INSTALLATION [09/2015 - ]