LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission [U881F] - Service Information (1 Of 2)) >> Transmission Control Cable >> Removal [09/2015 - 08/2016] >> Procedure

Removal [09/2015 - 08/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [09/2015 - 12/2017]

  2. SECURE VEHICLE 
    1. Fully apply the parking brake and chock a wheel.
      WARNING:
      • Make sure to apply the parking brake and chock a wheel before performing this procedure.
      • If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
      GTY655852Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2015 - 08/2016]

  4. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  5. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 2

  6. REMOVE BATTERY 

    See step  6

  7. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 2

  8. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20

  9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 21

  10. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [09/2015 - 12/2017]

  11. REMOVE FRONT NO. 1 CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 38

  12. REMOVE FRONT NO. 2 CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 39

  13. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY645124Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the transmission floor shift assembly.
      GTY630811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
      GTY645103Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with clip from the No. 1 transmission control cable bracket.
    6. Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.
      GTY444212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Disengage the 2 clamps.
      GTY645106Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Turn back the floor carpet.
      GTY679690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the 3 bolts and transmission control cable assembly from the cabin.
scientia non olet · About LEMON Manuals