Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during shift paddle switch (transmission shift switch assembly) removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System *1 | |||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] | ||
| Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] |
*1: When performing learning using the Techstream.