LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission [U881F] - Service Information (1 Of 2)) >> Shift Paddle Switch >> Installation [07/2020 - ] >> Procedure

Installation [07/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL NO. 1 SWITCH WIRE 

    HINT: 

    Perform this procedure only when replacement of the No. 1 switch wire is necessary.

    1. Engage the 6 clamps to install the No. 1 switch wire to the steering wheel assembly.
    2. Engage the 2 guides.
    3. Connect the steering vibration and heater ECU connector.
  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Connect the 2 shift paddle switch (transmission shift switch assembly) connectors.
    2. Engage the 2 claws to install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly.
    3. Install 4 new screws.

      Torque: 1.7 N*m (17 kgf*cm, 15 in.*lbf) 

  3. INSTALL STEERING PAD SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 1

  4. INSTALL CRUISE CONTROL MAIN SWITCH 

    Refer to PROCEDURE - Step 1

  5. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [07/2020 - ]

scientia non olet · About LEMON Manuals