Inspection [09/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
- Shift Paddle Switch (Transmission Shift Switch Assembly) LH:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Shift Paddle Switch (Transmission Shift Switch Assembly) LH)Standard Resistance
Tester Connection Condition Specified Condition 2 (ECC) - 1 (SDN) "-" continuously pulled Below 2.5 Ω Released 1 MΩ or higher If the result is not as specified, replace the shift paddle switch (transmission shift switch assembly) LH.
- Measure the resistance according to the value(s) in the table below.
- Shift Paddle Switch (Transmission Shift Switch Assembly) RH:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Shift Paddle Switch (Transmission Shift Switch Assembly) RH)Standard Resistance
Tester Connection Condition Specified Condition 3 (SUP) - 2 (ECC) "+" continuously pulled Below 2.5 Ω Released 1 MΩ or higher If the result is not as specified, replace the shift paddle switch (transmission shift switch assembly) RH.
- Measure the resistance according to the value(s) in the table below.
- Shift Paddle Switch (Transmission Shift Switch Assembly) LH: