LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission [U881F] - Service Information (1 Of 2)) >> DIFFERENTIAL OIL SEAL (for RH Side) >> Replacement [09/2015 - 08/2016] >> Procedure

Replacement [09/2015 - 08/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    NOTE:

    If automatic transaxle assembly parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary.

    Refer to PRECAUTION [09/2015 - 08/2016]

  2. REMOVE TRANSFER ASSEMBLY 

    Refer to REMOVAL [09/2015 - 08/2016]

  3. REMOVE TRANSAXLE CASE OIL SEAL 
    1. Using a screwdriver with its tip wrapped with protective tape, remove the transaxle case oil seal from the transaxle housing.
      GTY670550Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      Be careful not to damage the front differential case or transaxle housing.

  4. REMOVE FRONT DRIVE SHAFT OIL SEAL RH 
    1. Using SST, remove the front drive shaft oil seal RH from the front differential case.
      GTY661611Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09308-00010 
      NOTE:

      Be careful not to damage the front differential case.

  5. INSTALL FRONT DRIVE SHAFT OIL SEAL RH 
    1. Coat the lip of a new front drive shaft oil seal RH with MP grease.
      GTY671248Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Depth
    2. Using SST and a hammer, install the front drive shaft oil seal RH to the front differential case.
      • SST: 09950-60010 
        1. 09951-00410
      • SST: 09950-70010 
        1. 09951-07200

      Standard Depth

      21.5 to 22.5 mm (0.846 to 0.886 in.)

      NOTE:

      Do not damage the lip of the front drive shaft oil seal RH.

  6. INSTALL TRANSAXLE CASE OIL SEAL 
    1. Coat the lip of a new transaxle case oil seal with MP grease.
    2. Using SST and a hammer, install the transaxle case oil seal to the transaxle housing.
      GTY619278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Depth
      • SST: 09649-17010 
      • SST: 09950-70010 
        1. 09951-07200

      Standard Depth

      5.5 to 6.5 mm (0.217 to 0.256 in.)

      NOTE:
      • Make sure that the transaxle case oil seal is installed in the correct direction.
      • Do not damage the lip of the transaxle case oil seal.
  7. INSTALL TRANSFER ASSEMBLY 

    Refer to INSTALLATION [09/2015 - ]

scientia non olet · About LEMON Manuals