Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transaxle case oil seal and front drive shaft oil seal RH removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Memorize steering angle neutral point | Lane Control System | Refer to INITIALIZATION [08/2019 - ] |
| Pre-collision System | |||
| Intelligent Clearance Sonar System *1 | |||
| Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | ||
| Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power Back Door System (w/ Outside Door Control Switch) | Refer to INITIALIZATION [08/2019 - ] | |
| Replacement of automatic transaxle assembly | Perform the following procedures in the order shown:
|
|
Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to REGISTRATION [09/2015 - ] for Registration |
| Replacement of ECM (If possible, read the transaxle compensation code from the previous ECM) |
Perform the following procedures in the order shown:
|
||
| Replacement of ECM (If impossible, read the transaxle compensation code from the previous ECM) |
Perform the following procedures in the order shown:
|
||
| Front wheel alignment adjustment | Calibration |
|
Refer to CALIBRATION [08/2019 - ] |
| Suspension, tires, etc. (The vehicle height changes because of suspension or tire replacement) |
|
|
Refer to CALIBRATION [08/2019 - ] |
| Rear television camera assembly optical axis (Back camera position setting) | Parking Assist Monitor System | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
|
|
Panoramic View Monitor System | Refer to INITIALIZATION [08/2019 - ]
for Initialization Refer to CALIBRATION [08/2019 - ] for Calibration |
|
| Initialize No. 1 headlight ECU sub-assembly LH | Lighting System (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ] | |
| Replacement of throttle body with motor assembly | Inspection After Repair |
|
Refer to INITIALIZATION [08/2019 - ] |
| Cleaning the deposits from the throttle body with motor assembly | |||
| Air leaks from intake system is repaired | |||
| Gas leak from exhaust system is repaired | |||
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [09/2015 - ] |
| ECU communication ID registration (Immobilizer system) | Engine start function | Refer to REGISTRATION [08/2019 - 07/2021] , or refer to REGISTRATION [07/2021 - ] | |
| Perform code registration (Immobilizer system) |
|
Refer to REGISTRATION [08/2019 - 07/2021] , or refer to REGISTRATION [07/2021 - ] |
*1: When performing learning using the Techstream.