Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front wheel alignment adjustment	Clear zero point calibration data and system information. Perform yaw rate and acceleration sensor zero point calibration and store system information.	VSC disabled or malfunctions DTCs are stored Slip indicator light illuminates ABS warning light illuminates	Refer to CALIBRATION [09/2015 - 08/2019]