Inspection [09/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT COMBINATION SWITCH ASSEMBLY
- Inspect the NORMAL or NORMAL CUSTOMIZE mode switch:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 8 (B) - 1 (GND) Combination switch pushed and held Below 50 Ω Combination switch not pushed 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the SPORT or SPORT S/S+ mode switch:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 7 (P) - 1 (GND) Combination switch turned and held at SPORT or SPORT S/S+ position Below 50 Ω Combination switch not turned 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the illumination:
- Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.
*a Component without harness connected
(Combination Switch Assembly)Standard
Measurement Condition Specified Condition Battery positive (+) → Terminal 10 (ILL+)
Battery negative (-) → Terminal 6 (ILL-)Illuminates If the result is not as specified, replace the combination switch assembly.
- Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.
- Inspect the NORMAL or NORMAL CUSTOMIZE mode switch: