Inspection [08/2019 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT REAR CENTER ULTRASONIC SENSOR
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Rear Center Ultrasonic Sensor)Standard Resistance
Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below 1 Ω 5 (SI) - 2 (SO) Always Below 30 Ω 6 (EI) - 3 (EO) Always Below 1 Ω If the result is not as specified, replace the rear center ultrasonic sensor.
- Measure the resistance according to the value(s) in the table below.
- INSPECT REAR CORNER ULTRASONIC SENSOR
- for RH Side:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Rear Corner Ultrasonic Sensor RH)Standard Resistance
Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 (BO) Always Below 1 Ω 5 (SI) - 2 (SO) Always Below 30 Ω 6 (EI) - 3 (EO) Always Below 1 Ω If the result is not as specified, replace the rear corner ultrasonic sensor RH.
- Measure the resistance according to the value(s) in the table below.
- for LH Side:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Rear Corner Ultrasonic Sensor LH)Standard Resistance
Tester Connection Condition Specified Condition 4 (BI) - 6 (EI) Always 10 kΩ or higher 4 (BI) - 1 Always Below 1 Ω 5 (SI) - 2 Always Below 30 Ω 6 (EI) - 3 Always Below 1 Ω If the result is not as specified, replace the rear corner ultrasonic sensor LH.
- Measure the resistance according to the value(s) in the table below.
- for RH Side: