LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist & Monitoring System - Service Information) >> ULTRASONIC SENSOR (for Front) >> Inspection [09/2015 - 08/2019] >> Procedure

Inspection [09/2015 - 08/2019]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT NO. 1 ULTRASONIC SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY565900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 1 Ultrasonic Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      4 (BI) - 6 (EI) Always 10 kΩ or higher
      4 (BI) - 1 (BO) Always Below 1 Ω
      5 (SI) - 2 (SO) Always Below 30 Ω
      6 (EI) - 3 (EO) Always Below 1 Ω

      If the result is not as specified, replace the No. 1 ultrasonic sensor.

  2. INSPECT NO. 2 ULTRASONIC SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY565900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 2 Ultrasonic Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      4 (BI) - 6 (EI) Always 10 kΩ or higher
      4 (BI) - 1 (BO) Always Below 1 Ω
      5 (SI) - 2 (SO) Always Below 30 Ω
      6 (EI) - 3 (EO) Always Below 1 Ω

      If the result is not as specified, replace the No. 2 ultrasonic sensor.

scientia non olet · About LEMON Manuals