Caution / Notice / Hint
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during parking assist ECU removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | LKA /LDA system | Refer to INITIALIZATION [09/2015 - 08/2019] |
| Pre-collision system | |||
| Lighting system (w/ Automatic Headlight Beam Level Control System) | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| AFS (Adaptive Front-lighting System) | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Parking assist monitor system | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [09/2015 - 08/2019] | ||
| Initialize back door lock | Power door lock control system | Refer to INITIALIZATION [09/2015 - ] | |
| Reset back door close position | Power back door system | Refer to INITIALIZATION [09/2015 - 08/2019] | |
| Replacement of parking assist ECU |
|
Panoramic view monitor system | Refer to INITIALIZATION [09/2015 - 08/2019]
for Initialization Refer to CALIBRATION [09/2015 - 12/2017] for Calibration |