Installation [09/2015 - 08/2019]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PARKING ASSIST ECU
1. Install the parking assist ECU with the bolt and nut.
2. Connect each connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 15 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 15 [12/2017 - 08/2019]
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 16 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 16 [12/2017 - 08/2019]
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 2 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 2 [12/2017 - ]
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.

Refer to PROCEDURE - Step 43 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 42 [12/2017 - ]
INSTALL INSTRUMENT PANEL GARNISH RH
Refer to PROCEDURE - Step 19 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 19 [12/2017 - 08/2019]
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 8 [09/2015 - 12/2017] , or refer to PROCEDURE - Step 7 [12/2017 - 08/2019]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [09/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - 12/2017] , or refer to INITIALIZATION [12/2017 - 08/2019]
PERFORM PANORAMIC VIEW MONITOR SYSTEM CALIBRATION
Refer to CALIBRATION [09/2015 - 12/2017] , or refer to CALIBRATION [12/2017 - 08/2019]