LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist & Monitoring System - Service Information) >> Parking Assist Ecu >> Installation [08/2019 - ] >> Procedure

Installation [08/2019 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARKING ASSIST ECU 
    1. Install the parking assist ECU with the bolt and nut.
    2. Connect each connector.
  2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY 

    Refer to PROCEDURE - Step 15

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

  4. INSTALL COWL SIDE TRIM BOARD RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 2

  5. INSTALL FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 42

  6. INSTALL INSTRUMENT PANEL GARNISH RH 

    Refer to PROCEDURE - Step 19

  7. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 7

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [08/2019 - ]

  9. PERFORM PANORAMIC VIEW MONITOR SYSTEM CALIBRATION 

    Refer to CALIBRATION [08/2019 - ]

scientia non olet · About LEMON Manuals