Inspection [09/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT PANORAMIC VIEW MONITOR SWITCH (INTEGRATION CONTROL AND PANEL ASSEMBLY)
- Remove the panoramic view monitor switch (integration control and panel assembly).
Refer to REMOVAL [09/2015 - ]
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Panoramic View Monitor Switch (Integration Control and Panel Assembly))Standard Resistance
Tester Connection Switch Condition Specified Condition 5 (D) - 17 (E) Panoramic view monitor switch pushed Below 50 Ω Panoramic view monitor switch not pushed 1 MΩ or higher If the result is not as specified, replace the panoramic view monitor switch (integration control and panel assembly).
- Check that the switch illumination illuminates.
- Apply battery voltage to the panoramic view monitor switch and check that the switch illumination illuminates.
OK
Connection Specified Condition Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 15 (ILL-)Illuminates If the result is not as specified, replace the panoramic view monitor switch (integration control and panel assembly).
*a Component without harness connected
(Panoramic View Monitor Switch (Integration Control and Panel Assembly))
- Apply battery voltage to the panoramic view monitor switch and check that the switch illumination illuminates.
- Install the panoramic view monitor switch (integration control and panel assembly).
Refer to INSTALLATION [09/2015 - ]
- Remove the panoramic view monitor switch (integration control and panel assembly).