LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist & Monitoring System - Service Information) >> Blind Spot Monitor Sensor >> Removal [08/2019 - ] >> Procedure

Removal [08/2019 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR BUMPER ASSEMBLY (w/o Rear No. 2 Seat) 

    Refer to REMOVAL [08/2019 - ]

  2. REMOVE REAR BUMPER ASSEMBLY (w/ Rear No. 2 Seat) 

    Refer to REMOVAL [08/2019 - ]

  3. REMOVE BLIND SPOT MONITOR SENSOR LH 
    1. Disconnect the connector.
      GTY669434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 nuts and blind spot monitor sensor LH.
      NOTE:

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

  4. REMOVE BLIND SPOT MONITOR SENSOR RH 
    1. Disconnect the connector.
      GTY669433Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 nuts and blind spot monitor sensor RH.
      NOTE:

      Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

scientia non olet · About LEMON Manuals