LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350L FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Park Assist & Monitoring System - Service Information) >> Blind Spot Monitor Sensor >> Removal [08/2016 - 12/2017] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2022 Lexus RX 350, 2021 Lexus RX 350, 2020 Lexus RX 350, 2019 Lexus RX 350, and 2018 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of blind spot monitor sensor Blind Spot Monitor Beam Axis Adjustment
  • Intelligent clearance sonar system
  • Blind spot monitor system
 Refer to OPERATION CHECK [09/2015 - 12/2017]
Rear bumper assembly (w/ Intelligent clearance sonar system)
  • Ultrasonic sensor detection angle
  • Ultrasonic sensor detection angle registration
  • Intelligent clearance sonar system
  • Intuitive parking assist system (w/ Intelligent clearance sonar system)
 Refer to CALIBRATION [08/2016 - 12/2017]
scientia non olet · About LEMON Manuals