LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> RX 350 Base, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System - Service Information >> REAR SPEED SENSOR (for 2WD) >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. REMOVE REAR WHEEL 

    Refer to PROCEDURE - Step 1

  2. REMOVE REAR SUSPENSION ARM COVER 

    Refer to PROCEDURE - Step 3 [09/2015 - 08/2016] , or refer to PROCEDURE - Step 3 [08/2016 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - ]

  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY 

    Refer to PROCEDURE - Step 2

  4. REMOVE REAR DISC 

    Refer to PROCEDURE - Step 15

  5. SEPARATE REAR SKID CONTROL SENSOR WIRE 
    1. Remove the bolt and separate the rear skid control sensor wire.
      GTY620575Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver with its tip wrapped with protective tape, disconnect the rear skid control sensor wire connector from the rear axle hub and bearing assembly.
      NOTE:

      Be careful not to damage the rear axle hub and bearing assembly.

      GTY639224Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
  6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY 
    1. Remove the rear axle hub and bearing assembly.

      Refer to PROCEDURE - Step 8

      HINT: 

      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.
      • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
scientia non olet · About LEMON Manuals