Abnormal Brake Pedal Response on First Depression [11/2021 - ]: Procedure

1. Check the conditions at the time the problem occurred.
   1. Whether a warning light illuminated or the buzzer sounded.
   2. The number of times the ignition switch was turned to ON since the latest symptom occurred.
   3. Frequency of the symptom.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check the DTCs (electronically controlled brake system) that are output.

   Chassis > Brake Booster > Trouble Codes 

   Result

   Result	Proceed to
   DTCs C1256-00, C1256-09 and C1391-00 are not output.	A
   DTCs C1256-00, C1256-09 and/or C1391-00 are output.	B

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

Result: 

A 

See step  3

1. Turn the ignition switch off.
2. Depress the brake pedal within 4 minutes of opening the driver door and check the response of the brake pedal.
3. Release the brake pedal and wait for 4 minutes without depressing the brake pedal, opening or closing the driver door or operating the ignition switch.
4. After 4 minutes or more have elapsed, depress the brake pedal and check that the first depression response is different to successive depression responses.

   HINT: 

   Compare the response of the brake pedal when the system is in sleep mode and when the stroke simulator is operating.

   Result

   Result	Proceed to
   The response of the brake pedal does not change.	A
   The response of the brake pedal changed.	B

Result: 

B 

END 

Result: 

A 

See step  4

1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

   OK

   The connector is securely connected.

2. Disconnect the A39 No. 1 skid control ECU (brake booster with master cylinder assembly) connector.
3. Check both the connector case and the terminals for deformation and corrosion.

   OK

   No deformation or corrosion.

4. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   A39-40 (CTY) - Body ground	Driver door open	Below 1 V
   A39-40 (CTY) - Body ground	Driver door closed	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

Result: 

NG 

See step  5

1. Check that there is no open or short in the wire harnesses and connectors between terminal CTY of the No. 1 skid control ECU (brake booster with master cylinder assembly) and e-Latch ECU (front door lock with motor assembly (driver side)).

   OK

   No open/short.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

INSPECT E-LATCH SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR