Removal [11/2021 - ]: Procedure

Refer to PROCEDURE - Step 35

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

   -

   -

   1. Disengage the 4 claws.
   2. Remove the nut.
   3. Apply protective tape around the rear door lower outside moulding sub-assembly as shown in the illustration.
   4. Disengage the 4 clips and remove the rear door lower outside moulding sub-assembly as shown in the illustration.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Double-sided Tape	-	-
   	Heating Area	-	-

   1. Clean the vehicle body surface.

      1. Using a heat light, heat the double-sided tape remaining on the vehicle body and rear door panel protector.

      HEATING TEMPERATURE
      
      

      Area	Temperature	Area	Temperature
      Vehicle Body and Rear Door Panel Protector	40 to 60 °C (104 to 140 °F)	-	-

      WARNING:

      • Do not touch the heat light and heated parts, touching the heat light may result in burns.
      • Touching heated parts for a long time may result in burns.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Heated Part
      *b	Heat Light

      NOTE:

      Do not heat the vehicle body excessively.

   2. Disengage the 7 claws, 2 guides and separate the double-sided tape to remove the rear door panel protector.
   3. Remove any remaining double-sided tape from the vehicle body.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Apply protective tape around the outside moulding set as shown in the illustration.
   2. Remove the screw.
   3. Disengage the 5 clips and remove the outside moulding set.