Removal [11/2021 - 03/2024]: Procedure

Refer to REMOVAL [11/2021 - 03/2024]

Refer to PROCEDURE - Step 2

HINT: 

Perform the same procedure as for the LH side.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Wooden Block	*b	Jack
   	Wooden Block Placement Location	-	-

   1. Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.
      NOTE:

      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
      • Make sure to perform this operation with the vehicle kept as low as possible.
   2. Remove the bolt and nut, and separate the rear stabilizer link assembly LH from the rear No. 2 suspension arm assembly.
      NOTE:

      Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

HINT: 

Perform the same procedure as for the LH side.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the nut and the rear stabilizer link assembly LH from the rear stabilizer bar.

      HINT: 

      If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

HINT: 

Perform the same procedure as for the LH side.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002