LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> NX 350 Base >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Emission Control System - Service Information >> Vacuum Regulating Valve >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

  1. INSTALL VACUUM REGULATING VALVE ASSEMBLY 
    1. GTY1077633Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Vacuum Transmitting Hose Assembly *2 Vacuum Regulating Valve Assembly
      *3 No. 2 Vacuum Transmitting Hose Assembly - -
      *a 0 to 1 mm (0 to 0.0393 in.) - -
      1. Connect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose to the vacuum regulating valve.
        NOTE:
        • Make sure to slide the vacuum transmitting hose assembly until it contacts the hose stopper of the vacuum regulating valve assembly.
        • Make sure the tip of the hose is within the area shown in the figure.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

scientia non olet · About LEMON Manuals