Removal [12/2021 - ]: Procedure

Refer to REMOVAL [12/2021 - ]

Refer to PROCEDURE - Step 4

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Hold	-	-
   	Turn	-	-

   1. Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.
      • SST: 09213-58014 
        1. 09213-70020
      • SST: 09330-00021 
   2. Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley.
      • SST: 09950-50013 
        1. 09951-05010
        2. 09952-05010
        3. 09953-05010
        4. 09954-05021

      HINT: 

      Apply lubricant to the threads and end of SST.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Protective Tape

   -

   -

   1. Using a screwdriver with its tip taped, pry out the timing chain case oil seal.
      NOTE:

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.