Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the roof drip side finish moulding LH and rear roof drip side finish moulding LH removal/installation are shown below.
HINT:
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function when Necessary Procedures are not Performed Necessary Procedures Link Stop and start system* Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). Refer to PRECAUTION [12/2021 - 10/2023] , or refer to PRECAUTION [10/2023 - ] Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [12/2021 - ] Pre-collision system Lane tracing assist system Adaptive high beam system *: w/ Stop and start system
- Learning completes when vehicle is operated normally
Effect/Inoperative Function when Necessary Procedures are not Performed Necessary Procedures Link Power back door system Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.Refer to INITIALIZATION [12/2021 - ] Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. - - Use the same procedure for the RH and LH sides.
- Use the same procedure described for the LH side.