On-Vehicle Inspection [12/2021 - ]: Procedure
- INSPECT WASHER NOZZLE
- Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.
Standard
Center of washer fluid contacts the windshield in the areas shown in the illustration.
*a Upper Limit *b Standard *c Lower Limit - - Measurement - - Standard Measurement
Area Measurement Area Measurement A 100.9 mm (3.97 in.) B 94.2 mm (3.71 in.) C 276.4 mm (10.88 in.) D 109 mm (4.29 in.) HINT:
If the result is not as specified, replace the washer nozzle sub-assembly.
- Operate the washer nozzle sub-assemblies and check the position that the washer fluid contacts the windshield.