Caution / Notice / Hint

NOTE:

Some parts must be initialized and set when replacing or removing and installing parts.
Refer to WORK PROCEDURE [12/2021 - ]
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

HINT:

The meter illumination dims when the taillights are turned on.
Setting the meter illumination level to maximum brightness cancels the above dimming of the meter illumination.
Setting the meter illumination level to minimum brightness turns off the meter illumination.
The automatic light control sensor sensitivity can be customized.
w/o Adaptive High Beam System:

Refer to CUSTOMIZE PARAMETERS [12/2021 - ]

w/ Adaptive High Beam System:

Refer to CUSTOMIZE PARAMETERS [12/2021 - ]