Caution / Notice / Hint

NOTE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [12/2021 - ]
When disconnecting and reconnecting the battery
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [12/2021 - ]
Before preforming this procedure, check for Meter / Gauge System DTC B1500-13 or B1501-13* which is stored if an open or short in the circuit is detected. If DTC B1500-13 or B1501-13* is output, perform troubleshooting and repairs as necessary.
Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2021 - 10/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2023 - ]
1. *: w/ Fuel Sub Tank